1010PVNFM-3A
Index
Index-7
Calibration 4-10
Pick/Install XDCR Menu 2-21
Pick/Install XDCR Menu Structure 2-22
Pipe Class 2-6
Selecting 2-9
Pipe Configuration 2-18
Menu Structure 2-20
Option List Definitions 2-20
Selecting 2-20
Pipe Considerations For Clamp-on Transducer 5-2
Pipe Data Menu 2-6
Outer Diameter, Wall Thickness, 2-10
Pipe Data Menu Structure 2-8
Pipe Dimensions 5-2
Pipe Material 2-10
Selecting 2-10
Pipe Outer Diameter 2-10, 4-3
Selecting 2-10, 4-3
Pipe Parameters 1-1, 2-6
Pipe Size 2-9
Selecting 2-10
Pipe Table 4-2
Accessing Menu 4-2
Factory Settings 4-2
Pipe Temperature Range 2-19
Selecting 2-19
Pipe Wall Thickness 4-3
POSFLOW 2-36, 2-42
Power Failure 2-1
Preparing The Pipe Surface 3-3
Print Site Setup 5-19
R
Recall Site Command 2-2
Recall Site Setup 2-1
Reference Hole 3-13
Reflect Mode
Mounting Frames and Spacer Bar 3-9
With Spacer Bar Only 3-10
Reflect Mount 3-17
Installation With Mounting Track 3-17
Relay Option List 2-63
Relay Setup 2-63, 5-17
Assigning Relay Functions 2-63
ReversaMatic
TM
2-30
Reynolds Number 2-20 (See also Section 5 Reference Tables)
Compensation Factors, table 5-9
RS-232 Setup Menu 4-13
Baud Rate 4-13
Parity 4-14
RTD 4-10
Calibrate Menu 4-10
Calibration By Data Entry 4-11
Entering Current RTD Temperature 4-11
Ice Bath Calibration 4-11
To Next Page
Loading...
