99
4.4.3 Power ON/OFF
4.4.3.1 Manual Power ON/OFF
Restarting the inverter is required after regulation setting or manual
(fault) shut-down. Press ESC or ENT to access the Main Menu.
Scroll the curser down to highlight POWER ON/OFF and press
ENT to select. Move the cursor to “ON” and press ENT to start the
inverter. The inverter will start up and operate normally if the
start-up conditions are met. Otherwise, the inverter will go to
stand-by mode.
Normally, it is not necessary to Turn OFF the inverter, but it can be
shut down manually if regulation setting or maintenance is required.
Move the cursor from the main operation interface to POWER
ON/OFF and press ENT. Move the cursor to “OFF” and press ENT,
and then the inverter will be shut down.
4.4.3.2 Automatic Turn ON/OFF
The inverter will start up automatically when the output voltage and
power of PV arrays meet the set value, AC power grid is normal,
and the ambient temperature is within allowable operating range.
The inverter will be shut down automatically when the output
voltage and power of PV modules are lower than the set value, the
AC power grid fails, or the ambient temperature exceeds the
normal range.
To Next Page
Loading...
