78
9. Clear Running Record.
Clear the running information. This
contains normal operating information such as when the inverter
starts up and shuts down.
9. Clear Fault Record. Clear the fault record for the inverter. The
Fault Record can store up to 100 faults.
4.4.2.2 Control Command
There are five submenus in the “
Control Command
” menu:
Control Command
Factory Defaults
ARC Detect
Force Restart
ARC Clear
P1/2
Figure 4-12 Control Command Setting
1. Force
Restart.
If a fault shutdown happens, a severe fault may
have occurred inside the inverter. The user can perform a force
reboot for one time in this menu if the user needs to restart the
inverter.
INSTRUCTION:
Force Restart
is effective only when the faults “IntFault0010~0150” in
the troubleshooting table occur. The inverter may restore to normal
operation automatically if alarm or protection faults occur. This
function will not respond when the inverter is in operation mode and a
“FaultOperated” alarm interface will be indicated.
To Next Page
Loading...
