Product Manual — Doc. 9349B Crestron Zūm® Wired Solutions • 143
Perform a Factory Reset on a Load Controller
On the load controller, press and hold the TEST button for 10 seconds. Release the button when
all LEDs turn red. Wait a few seconds for the factory reset to finish.
NOTES:
l
Performing a factory reset on the primary Zūm Wired load controller restores the
space to default functionality and resets the load controller as a secondary device that
no longer controls the space. Refer to Assign a Load Controller as the Primary
Controller on page 144.
l
Performing a factory reset on any other Zūm Wired load controller or device in the
space only restores the default settings for that device.
To Next Page
Loading...
