Crestron Zum - Page 167

Product Manual — Doc. 9349B Crestron Zūm® Wired Solutions • 167
NOTE: The numbers below correspond with the numbers in the Main screen diagram.
1. Room Settings: Edit the Room Name, PIN, Floor ID, Zone ID, and Network information.
2. Configuration: Edit the room logic to view the current state of the room.
l
Occupancy Sensors: View details for the connected sensor(s) or edit the sensor
name.
l
Photo Sensors: View details for the connected sensor(s) or edit the sensor name.
l
Load Controllers: Identify and view details for the connected load controller(s).
o
ZUMLINK-JBOX-16A-LV and ZUMNET-JBOX-16A-LV load controllers:
n
View Current Scene, Daylighting status, and Output Level.
n
Override: The state of the load when Override is recalled. Click the
toggle to turn the load on or off during Override.
n
Assign the occupancy mode (Occupancy menu), vacancy mode
(Vacancy menu), vicinity mode (Vicinity menu), and daylight harvesting
(Photo menu) to specific load controllers.
n
View Dimming Values
n
Edit the Dimming Curve Configuration or Dimmer Scenes
Configuration.
o
ZUMLINK-JBOX-20A-PLUG load controller:
n
Override: The state of the load when Override is recalled. Click the
toggle to turn the load on or off during Override.
n
Assign the occupancy mode (Occupancy menu), vacancy mode
(Vacancy menu), vicinity mode (Vicinity menu), and daylight harvesting
(Photo menu) to specific load controllers.
o
ZUMLINK-JBOX-20A-SW load controller:
n
Closed: Click the toggle to turn the load on or off.
n
Override: The state of the load when Override is recalled. Click the
toggle to turn the load on or off during Override.
n
Assign the occupancy mode (Occupancy menu), vacancy mode
(Vacancy menu), vicinity mode (Vicinity menu), and daylight harvesting
(Photo menu) to specific load controllers.
n
Scenes: Allow keypad access to the scene by selecting or deselecting the
checkbox. Determine the state of the load when the scene is recalled by
clicking the toggle on or off.