168 • Crestron Zūm® Wired Solutions Product Manual — Doc. 9349B
o
ZUMLINK-EXP-16A-DIMU load controller:
n
View Current Scene, Daylighting status, and Output Level.
n
Override: The state of the load when Override is recalled. Click the
toggle to turn the load on or off during Override.
n
Assign the occupancy mode (Occupancy menu), vacancy mode
(Vacancy menu), vicinity mode (Vicinity menu), and daylight harvesting
(Photo menu) to specific load controllers.
n
View Dimming Values.
n
Edit the Dimmer Scenes Configuration.
l
Scenes: View and edit room scenes: Scene 1 - Scene 16. When editing the scene, tap
the Identify icon to identify the load controller. The load controller emits a sound
and flashes the Link LED. The connected loads also flash.
l
Keypads: Identify and view details for the connected keypad(s). Edit the keypad
name and assign the button layout.
o
Adjust the Double Tap Speed: Set the amount of time between two button
presses to qualify as a double tap.
o
Specify the Button Layout and click on a button to configure button actions.
Button action options:
n
None
n
Off: Assigned load controllers turn off.
n
On: Assigned loads turn on.
n
Raise: Assigned load controllers raise.
n
Toggle: Switches load controllers between ON and OFF states
n
Lower: Assigned load controllers lower.
n
Recall Scene 1 - Scene 16: Assigned load controllers recall the behavior
set for the specified scene.
n
Export to Hub: Name and send information to ZUM-HUB4 for macro
actions.
l
Load Shedding: Set the maximum levels for load shedding.
l
Load/Sensor Groups: Create groups within the room.
l
DALI Controllers: Address drivers, create DALI groups, assign drivers, and identify
drivers.
l
Current Scene: Displays the current room scene.
l
Occupancy Status: Displays occupied or vacant. If any area of the room is occupied,
then the status is Occupied. When all areas of the room are vacant, the status is
Vacant.
3. Firmware: To update firmware, refer to Update Firmware with the Zūm App on page 153..
To Next Page
Loading...
