Culligan CTM Series User Manual

Service and Repair 63
Cat. No. 01029401
Pilot Valve Reassembly
Figure 77.
Enclosure #2 Screws
1. Replace clamp and
tighten the 4 #2 screws
CAUTION! Ensure the
o-ring is in place
when replacing
the enclosure.
2. Reconnect electrical
connections, making
sure to route through
the enclosure
3. Connect tubing (page 20)
through the enclosure.
4. Repressurize unit (page
43)
5. Cycle valve, while checking
the pilot valve for leaks
6. If no leaks, replace
enclosure and tighten
with #2 screws.

Culligan CTM Series Specifications

General

Power Source	Electric
Voltage	120V
Type	Countertop
Dispensing Options	Cold
Filter Life	6 months