Curtiss-Wright Parvus SWI-22-10-10 - Exiting Parvus Debug Mode

Appendix B Parvus CLI Enhancements
Parvus SWI-22-10
Curtiss-Wright
Page 100 of 107
MNL-0641-01 Rev A3
ECO-4823
Effective: 04 Oct 16
EXITING PARVUS DEBUG MODE
To exit debug mode, you need to return to the root level and then reboot the switch. You can use either
the up command or a /.
1. Type 'up' to move up one level or '/' to go to root level.
SWI2210-XXXX:/Debug/Parvus>up
SWI2210-XXXX:/Debug>/
SWI2210-XXXX:/>
2. Type 'system' to access the system level.
SWI2210-XXXX:/>system
3. Type 'reboot'. The system reboots.
SWI2210-XXXX:/>reboot