Curtiss-Wright Parvus SWI-22-10-10 User Manual

MNL-0641-01 Rev A3
ECO-4823
Effective: 04 Oct 16
Page 101 of 107
COMMANDS OVERVIEW
 Commands are persistent, meaning values are changed immediately and written to permanent
storage.
 Commands are not case-sensitive. They are displayed with capitals for readability.
 Commands cannot be abbreviated.
 As shown in the summary table, some commands are for manufacturing use only (e.g., Built-in
Test); others should not be changed. Using these commands may wipe out all configuration
data, requiring a complete reload of firmware and configuration.
Type
Command
Description
Built-In Test
BitClear
TEST--Manufacturing Use Only
BitInterval <integer>
TEST--Manufacturing Use Only
BitStatus
TEST--Manufacturing Use Only
EEPROM
EeDump <addr> <item_cnt>
Displays fault logging
EeFill <addr> <item_cnt> <fill_val>
TEST--Manufacturing Use Only
LED
LED
TEST--Manufacturing Use Only
Log
LogAddEntry
TEST--Manufacturing Use Only
LogErase
Erases the fault log
LogShow
Displays the fault log
OptDefaults
OptShow
OptWrapFaultLog <integer>
Temperature
OptTCritical <integer> <integer>
OptTDisplay <integer>
OptTWarning <integer> <integer>
Zeroization
OptZDelay <integer>
Zeroization delay parameter
OptZEnable <integer>
Zeroization enable parameter
OptZPolarity <integer>
DO NOT CHANGE
OptZStyle <integer>
DO NOT CHANGE
Switch Data
Status
Debug status
Temp
TEST--Manufacturing Use Only
Uptime
Lifetime counter
Version
Displays the Parvus version number
WatchdogEnable <integer>
DO NOT CHANGE
XoShow
TEST--Manufacturing Use Only
XoUp
TEST--Manufacturing Use Only

Curtiss-Wright Parvus SWI-22-10-10 Specifications

General

Brand	Curtiss-Wright
Model	Parvus SWI-22-10-10
Category	Switch
Language	English