Curtiss-Wright Parvus SWI-22-10-10 User Manual

Appendix B Parvus CLI Enhancements
Parvus SWI-22-10
Curtiss-Wright
Page 104 of 107
MNL-0641-01 Rev A3
ECO-4823
Effective: 04 Oct 16
optwrapfaultlog
Enables or disables fault log wrapping. If wrapping is enabled and the fault log is full, the fault log wraps
and overwrites older entries. Otherwise it stops accepting new entries.
Syntax
Debug Parvus OptWrapFaultLog <integer>
<integer> is 1 (enable) or 0 (disable) fault log wrapping
Example
SWI2210-XXXX:/Debug/Parvus>optwrapfaultlog
LogErase
Erases the entire fault log. Depending on the number of entries, this may require several minutes to
complete.
Syntax
logerase
Example
SWI2210-XXXX:/Debug/Parvus>logerase
Erasing fault log. Remaining locations...XXXXXXX
A counter decrements as the locations are erased. When the erasure is complete, the system reboots.
Status
Shows the status of Parvus extensions.
Syntax
status
Example
SWI2210-XXXX:/Debug/Parvus>status
Parvus thread has run 54442 times.
Zeroize input is not asserted.
Temp
Displays temperature readings.
Syntax
temp
Example
SWI2210-XXXX:/Debug/Parvus>temp
Temp readings...
LOCAL = 51.0 deg C.
SWITCH = 68.0 deg C.
PHY1 = 54.4 deg C.
PHY2 = 55.0 deg C.
SWI2210-XXXX:/Debug/Parvus>
Uptime
Displays up-time and service life (operational hours).

Curtiss-Wright Parvus SWI-22-10-10 Specifications

General

Brand	Curtiss-Wright
Model	Parvus SWI-22-10-10
Category	Switch
Language	English