CHAPTER 1 INTRODUCTION
The SWI-22-10 is a rugged PCI/104-Express Gigabit Ethernet Switch card equipped with up to twenty
triple-speed 10/100/1000Mbps ports for connecting IPv4- and IPv6-compatible computing devices in
demanding embedded systems LAN applications.
ABOUT THIS DOCUMENT
This manual provides functional and technical descriptions of the SWI-22-10 hardware, instructions on
connecting the card to test equipment, operational information on using the SWI-22-10 management
consoles and commands, connector descriptions and pinouts, and specifications.
DEFINITIONS
Please refer to the Glossary at the end of this document for an explanation of networking terms used in
this manual.
DESCRIPTION OF SAFETY SYMBOLS
The following symbols are used in this manual to indicate important information and potentially dangerous
situations.
Warning! Danger, electrical shock hazard!
Personal injury or death could occur. Also damage to the system, connected peripheral devices, or
software could occur if the warnings are not followed carefully.
Caution! Hazard to individuals, environment, devices, or data!
If you do not adhere to the safety advice next to this symbol, there is obvious hazard to individuals, to
environment, to materials, or to data.
To Next Page
Loading...
Need help?
General
