EXEC Commands
The EXEC commands include the following:
SWI2210-XXXX# ?
clear Reset functions
configure Enter configuration mode
copy Copy from source to destination
debug Debugging functions
delete Delete one file in flash: file system
dir Directory of all files in flash: file system
disable Turn off privileged commands
do To run exec commands in config mode
dot1x IEEE Standard for port-based Network Access Control
enable Turn on privileged commands
erps Ethernet Ring Protection Switching
exit Exit from EXEC mode
firmware Firmware upgrade/swap
help Description of the interactive help system
ip IPv4 commands
link-oam Link OAM configuration
logout Exit from EXEC mode
more Display file
no Negate a command or set its defaults
ping Send ICMP echo messages
ptp Enable wireless mode for an interface.
reload Reload system.
send Send a message to other tty lines
show Show running system information
terminal Set terminal line parameters
SWI2210-XXXX#
Show Commands
Show commands display switch configuration, statistics, and other information.
SWI2210-XXXX# show ?
aaa Login methods
access Access management
access-list Access list
aggregation Aggregation port configuration
clock Configure time-of-day clock
dot1x IEEE Standard for port-based Network Access Control
eps Ethernet Protection Switching
erps Ethernet Ring Protection Switching
evc Ethernet Virtual Connections
green-ethernet Green ethernet (Power reduction)
history Display the session command history
interface Interface status and configuration
ip Internet Protocol
ipmc IPv4/IPv6 multicast configuration
ipv6 IPv6 configuration commands
lacp LACP configuration/status
line TTY line information
link-oam Link OAM configuration
lldp Display LLDP neighbors information.
logging Syslog
loop-protect Loop protection configuration
mac Mac Address Table information
mep Maintenance Entity Point
mvr Multicast VLAN Registration configuration
network-clock Show selector state.
ntp Configure NTP
platform Platform specific information
poe Power Over Ethernet.
port-security
privilege Display command privilege
ptp Precision time Protocol (1588)
pvlan PVLAN configuration
qos Quality of Service
radius-server RADIUS configuration
rmon RMON statistics
running-config Show running system information
sflow Statistics flow.
snmp Display SNMP configurations
spanning-tree STP Bridge
switchport Display switching mode characteristics
tacacs-server TACACS+ configuration
terminal Display terminal configuration parameters
To Next Page
Loading...
Need help?
General
