Configuring SNMP
Configuring SNMP Notifications
Page 181
SNMPv3 Notification Recipient
The SNMPv3 Notification Recipient table contains the following fields:
• Recipient IP — Displays the IP address to which the traps are sent.
• Notification Type — Displays the type of notification sent. The possible field values are:
– Trap — Indicates that traps are sent.
– Inform — Indicates that informs are sent.
• User Name — Displays the user to which SNMP notifications are sent.
• Security Level — Displays the means by which the packet is authenticated. The possible field values are:
– No Authentication — Indicates that the packet is neither authenticated nor encrypted.
– Authentication — Indicates that the packet is authenticated.
• UDP Port — The UDP port used to send notifications. The field range is 1-65535. The default is 162.
• Filter Name — Includes or excludes SNMP filters.
• Timeout — The amount of time (seconds) the device waits before resending informs. The field range is 1-
300. The default is 10 seconds.
• Retries — The amount of times the device resends an inform request. The field range is 1-255. The default is
3.
• Remove — Deletes the currently selected recipient. The possible field values are:
– Checked — Removes the selected recipient from the list of recipients.
– Unchecked — Maintains the list of recipients.
2. Click . The Add SNMP Notification Receiver Page opens:
Figure 116:Add SNMP Notification Receiver Page
To Next Page
Loading...
