DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
139
12-6 enable telnet
Description
This command is used to enable the Switch’s TELNET based management software.
Format
enable telnet {<tcp_port_number 1-65535>}
Parameters
<tcp_port_number 1-65535> - (Optional) The TCP port number. TCP ports are numbered
between 1 and 65535. The “well-known” TCP port for the TELNET protocol is 23.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable TELNET and configure port number:
DWS-3160-24PC:admin# enable telnet 23
Command: enable telnet 23
Success.
12-7 disable telnet
Description
This command is used to disable the Switch’s TELNET based management software.
Format
disable telnet
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To disable TELNET:
To Next Page
Loading...
