D-Link DWS-3160-24TC - Enable Pvid Auto Assign

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
33
Parameters
<portlist> - (Optional) Specifies a range of ports to be displayed.
If no parameter specified, system will display all ports gvrp information.
Restrictions
None.
Example
To display the 802.1Q port setting:
DWS-3160-24PC:admin#show port_vlan
Command: show port_vlan
Port PVID GVRP Ingress Checking Acceptable Frame Type
------- ---- -------- ---------------- ---------------------------
1 1 Disabled Enabled All Frames
2 1 Disabled Enabled All Frames
3 1 Disabled Enabled All Frames
4 1 Disabled Enabled All Frames
5 1 Disabled Enabled All Frames
6 1 Disabled Enabled All Frames
7 1 Disabled Enabled All Frames
8 1 Disabled Enabled All Frames
9 1 Disabled Enabled All Frames
10 1 Disabled Enabled All Frames
11 1 Disabled Enabled All Frames
12 1 Disabled Enabled All Frames
13 1 Disabled Enabled All Frames
14 1 Disabled Enabled All Frames
15 1 Disabled Enabled All Frames
16 1 Disabled Enabled All Frames
17 1 Disabled Enabled All Frames
18 1 Disabled Enabled All Frames
19 1 Disabled Enabled All Frames
20 1 Disabled Enabled All Frames
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
3-12 enable pvid auto assign
Description
The command is used to enable the auto-assignment of PVID.
If this feature is enabled, the PVID will possibly be changed by the PVID or the VLAN configuration.
When a user configures a port to VLAN X’s untagged membership, this port’s PVID will be updated
with VLAN X. The PVID is updated with the last item of the VLAN list. When a user removes a port
from the untagged membership of the PVID’s VLAN, the port’s PVID will be assigned with a
‘default VLAN’ parameter.
By default, this setting is enabled.