D-Link DWS-3160-24TC - Config Loopdetect Log

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
418
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To Specifies that traps will be sent when the loop condition is detected or cleared:
DWS-3160-24PC:admin# config loopdetect trap both
Command: config loopdetect trap both
Success.
DWS-3160-24PC:admin#
40-8 config loopdetect log
Description
This command is used to configure the log state for LBD. The default value is enabled.
Format
config loopdetect log state [enable | disable]
Parameters
state - Specifies the state of the LBD log feature.
enable - Enable the LBD log feature.
disable - Disable the LBD log feature. All LBD-related logs will not be recorded.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the log state for LBD:
DWS-3160-24PC:admin# config loopdetect log state enable
Command: config loopdetect log state enable
Success.
DWS-3160-24PC:admin#