D-Link DWS-3160-24TC - Show Lldp

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
403
DWS-3160-24PC:admin# config lldp ports all dot1_tlv_protocol_identity all
enable
Command: config lldp ports all dot1_tlv_protocol_identity all enable
Success.
DWS-3160-24PC:admin#
To configure exclude the MAC/PHY configuration/status TLV from the outbound LLDP
advertisements for all ports:
DWS-3160-24PC:admin# config lldp ports all dot3_tlvs
mac_phy_configuration_status enable
Command: config lldp ports all dot3_tlvs mac_phy_configuration_status enable
Success.
DWS-3160-24PC:admin#
39-6 config lldp forward_ message
Description
This command is used to configure forwarding of LLDP PDU packets when LLDP is disabled.
Format
config lldp forward_message [enable | disable]
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure LLDP to forward LLDP PDUs:
DWS-3160-24PC:admin# config lldp forward_message enable
Command: config lldp forward_message enable
Success.
DWS-3160-24PC:admin#
39-7 show lldp
Description
This command is used to display the Switch’s general LLDP configuration status.