DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
404
Format
show lldp
Parameters
None.
Restrictions
None.
Example
To display the LLDP system level configuration status:
DWS-3160-24PC:admin#show lldp
Command: show lldp
LLDP System Information
Chassis ID Subtype : MAC Address
Chassis ID : 00-11-22-33-45-67
System Name :
System Description : Gigabit Ethernet Switch
System Capabilities : Repeater, Bridge
LLDP Configurations
LLDP Status : Enabled
LLDP Forward Status : Enabled
Message TX Interval : 30
Message TX Hold Multiplier: 4
ReInit Delay : 2
TX Delay : 2
Notification Interval : 10
39-8 show lldp mgt_addr
Description
This command is used to display the LLDP management address information.
Format
show lldp mgt_addr {ipv4 <ipaddr> | ipv6 <ipv6addr>}
Parameters
- (Optional) Specifies the IPv4 address used for the display.
<ipaddr> - Enter the IPv4 address used for this configuration here.
To Next Page
Loading...
