D-Link DWS-3160-24TC - Config Stp Priority

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
494
Parameters
version – Specifies that the STP version will be configured.
mstp – Specifies that the STP version will be configured as Multiple Spanning Tree Protocol.
rstp - Specifies that the STP version will be configured as Rapid Spanning Tree Protocol.
stp - Specifies that the STP version will be configured as Spanning Tree Protocol.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the STP version:
DWS-3160-24PC:admin# config stp version mstp
Command: config stp version mstp
Success.
DWS-3160-24PC:admin#
To configure the STP version with the same value of old configuration:
DWS-3160-24PC:admin# config stp version mstp
Command: config stp version mstp
Configure value is the same with current value.
Success.
DWS-3160-24PC:admin#
48-12 config stp priority
Description
This command is used to configure the STP instance’s priority.
Format
config stp priority <value 0-61440> instance_id <value 0-15>
Parameters
priority - Specifies the bridge priority value. This value must be divisible by 4096.
<value 0-61440> - Enter the bridge priority value here. This value must be between 0 and
61440.
instance_id - Identifier to distinguish different STP instances.
<value 0-15>
- Enter the STP instance ID here. This value must be between 0 and 15.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.