DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
257
Restrictions
Only Administrators can issue this command.
Example
To set the Switch to not need a reboot when a fatal error occurs:
DWS-3160-24PC:admin# debug config error_reboot disable
Command: debug config error_reboot disable
Success.
22-5 debug config state
Description
Use the command to set the state of the debug.
Format
debug config state [enable | disable]
Parameters
enable - Enable the debug state.
disable - Disable the debug state.
Restrictions
Only Administrators can issue this command.
Example
To set the debug state to disabled:
DWS-3160-24PC:admin# debug config state disable
Command: debug config state disable
Success.
DWS-3160-24PC:admin#
22-6 debug show arpunresolved_list
Description
This command is used to debug the ARP unresolved list.
To Next Page
Loading...
