D-Link DWS-3160-24TC - Config Poe Ports

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
531
Example
To config PoE system-wise was setting:
DWS-3160-24PC:admin#config poe system power_limit 250 power_disconnect_method
deny_low_priority_port
Command: config poe system power_limit 250 power_disconnect_method
deny_low_priority_port
Success.
DWS-3160-24PC:admin#
55-2 config poe ports
Description
This command is used to configure the PoE port settings.
Based on 802.3af, there are 5 kinds of PD classes, class 0, class 1, class 2, and class 3. The
power consumption ranges for them are 0.44~12.95W, 0.44~3.84W, 3.84~6.49W, 6.49~12.95W,
and 12.95~ 29.5W, respectively.
The five pre-defined settings are for users’ convenience: The following is the power limit applied to
the port for these four classes. For each class, the power limit is a little more than the power
consumption range for the class. This takes the factor of the power loss on cable into account.
Thus, the following are the typical values defined by the chip vendor.
• Class 0: 15400mW
• Class 1: 4000mW
• Class 2: 7000mW
• Class 3: 15400mW
Other than these four pre-defined settings, users can directly specify any value that the chip
supports. Normally, the minimum setting is 1000mW, and the maximum setting is 15400mW for
802.3af and >=35000mW for 802.3at.
Format
config poe ports [all | <portlist>] { state [enable | disable] | [time_range <range_name 32> |
clear_time_range] | priority [critical | high | low] | power_limit [class_0 | class_1 | class_2 |
class_3 | user_define <value 1000-35000>]}
Parameters
ports - Specified the list of ports whose setting is under configuration.
all - Specifies that all the ports will be included in this configuration.
<portlist>
- Enter the list of port used for this configuration here.
state - (Optional) When the state is set to disable, power will not be supplied to the powered
device connected to this port.
enable - Specifies that state will be enabled.
disable - Specifies that state will be disabled.
time_range - (Optional) Specifies the time range that applies to the port of the POE. If time range
is configured, the power can only be supplied during the period specified by time range.
<range_name 32> - Enter the time range name here. This name can be up to 32 characters