D-Link DWS-3160-24TC - Enable Stp

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
492
48-8 config stp mst_config_id
Description
This command is used to change the name or the revision level of the MST configuration
identification.
Format
config stp mst_config_id {revision_level <int 0-65535> | name <string>}
Parameters
name - (Optional) Specifies the name given for a specific MST region.
<string> - Enter the MST region name here.
revision_level - (Optional) The same given name with different revision level also represents
different MST regions.
<int 0-65535> - Enter the revision level here. This value must be between 0 and 65535.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To change the name and revision level of the MST configuration identification:
DWS-3160-24PC:admin# config stp mst_config_id name R&D_BlockG revision_level 1
Commands: config stp mst_config_id name R&D_BlockG revision_level 1
Success.
DWS-3160-24PC:admin#
48-9 enable stp
Description
This command is used to enable STP globally.
Format
enable stp
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.