D-Link DWS-3160-24TC - Enable Snmp Traps; Disable Snmp Traps

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
622
66-24 enable snmp traps
Description
This command is used to enable SNMP trap support.
Format
enable snmp traps
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable SNMP trap support:
DWS-3160-24PC:admin# enable snmp traps
Command: enable snmp traps
Success.
DWS-3160-24PC:admin#
66-25 disable snmp traps
Description
This command is used to disable SNMP trap support on the Switch.
Format
disable snmp traps
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To prevent SNMP traps from being sent from the Switch: