D-Link DWS-3160-24TC - Config Snmp Engineid

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
617
Parameters
v6host - (Optional) Specifies the IPv6 host address.
<ipv6addr> - Enter the IPv6 address used for the configuration here.
If no parameter specified, all SNMP hosts will be displayed.
Restrictions
None.
Example
To display SNMP host:
DWS-3160-24PC:admin# show snmp v6host
Command: show snmp v6host
SNMP Host Table
------------------------------------------------------------------
Host IPv6 Address : 3FFE::3
SNMP Version : V3 na/np
Community Name/SNMPv3 User Name : initial
Host IPv6 Address : 3FFE::2
SNMP Version : V2c
Community Name/SNMPv3 User Name : private
Host IPv6 Address : 3FFE::1
SNMP Version : V1
Community Name/SNMPv3 User Name : public
Host IPv6 Address : 3FFE::3
SNMP Version : V3 a/np
Community Name/SNMPv3 User Name : user123
Host IPv6 Address : 3FFE::3
SNMP Version : V3 a/ p
Community Name/SNMPv3 User Name : user234
Total Entries: 5
DWS-3160-24PC:admin#
66-17 config snmp engineID
Description
This command is used to configure a identifier for the SNMP engine on the Switch.
Format
config snmp engineID <snmp_engineID 10-64>