D-Link DWS-3160-24TC - Config Accounting Service

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
63
DWS-3160-24PC:admin# show acct_client
Command: show acct_client
radiusAcctClient ==>
radiusAcctClientInvalidServerAddresses 0
radiusAcctClientIdentifier
radiusAuthServerEntry ==>
radiusAccServerIndex : 1
radiusAccServerAddress 10.48.74.121
radiusAccClientServerPortNumber 1813
radiusAccClientRoundTripTime 0
radiusAccClientRequests 0
radiusAccClientRetransmissions 0
radiusAccClientResponses 0
radiusAccClientMalformedResponses 0
radiusAccClientBadAuthenticators 0
radiusAccClientPendingRequests 0
radiusAccClientTimeouts 0
radiusAccClientUnknownTypes 0
radiusAccClientPacketsDropped 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
4-30 config accounting service
Description
This command is used to configure the state of the specified RADIUS accounting service.
Format
config accounting service [network | shell | system] state [enable | disable]
Parameters
network - Accounting service for 802.1X port access control. By default, the service is disabled.
shell - Accounting service for shell events: When user logs on or out the Switch (via the console,
TELNET, or SSH) and timeout occurs, accounting information will be collected and sent to
RADIUS server. By default, the service is disabled.
system - Accounting service for system events: reset, reboot. By default, the service is disabled.
state - Specifies the state of the specified service.
enable - Specifies to enable the specified accounting service.
disable
- Specifies to disable the specified accounting service.
Restrictions
Only Administrators and Operators can issue this command.