D-Link DWS-3160-24TC - Show Dscp Map

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
564
These DSCP mapping will take effect at the same time when IP packet ingress from a DSCP-
trusted port.
Format
config dscp map {[<portlist> | all]} [dscp_priority <dscp_list> to <priority 0-7> | dscp_dscp
<dscp_list> to <dscp 0-63>]
Parameters
<portlist> - Enter the list of port used for this configuration here.
all - Specifies that all the ports will be included in this configuration.
dscp_priority - Specifies a list of DSCP value to be mapped to a specific priority.
<dscp_list> - Enter the DSCP priority list here.
to - Specifies that the above or following parameter will be mapped to the previously mentioned
parameter.
<priority 0-7> - Specifies the result priority of mapping.
dscp_dscp - Specifies a list of DSCP value to be mapped to a specific DSCP.
<dscp_list> - Enter the DSCP to DSCP list here.
to - Specifies that the above or following parameter will be mapped to the previously mentioned
parameter.
<dscp 0-63> - Specifies the result DSCP of mapping.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the mapping of the DSCP priority to priority 1:
DWS-3160-24PC:admin#config dscp map 1-8 dscp_priority 1 to 1
Command: config dscp map 1-8 dscp_priority 1 to 1
Success.
DWS-3160-24PC:admin#
To configure the global mapping of the DSCP priority to priority 1:
DWS-3160-24PC:admin#config dscp map dscp_priority 1 to 1
Command: config dscp map dscp_priority 1 to 1
Success.
DWS-3160-24PC:admin#
59-19 show dscp map
Description
This command is used to display the DSCP trusted port list and mapped color priority.