D-Link DWS-3160-24TC - Config Configuration

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
207
DWS-3160-24PC:admin#show config effective
Command: show config effective
#------------------------------------------------------------------------------
# DWS-3160-24PC Gigabit Ethernet Switch
# Configuration
#
# Firmware: Build 1.00.034
# Copyright(C) 2012 D-Link Corporation. All rights reserved.
#------------------------------------------------------------------------------
# DEVICE
config temperature threshold high 79
config temperature threshold low 11
config temperature trap state enable
config temperature log state enable
# BASIC
# ACCOUNT LIST
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
18-2 config configuration
Description
This command is used to select a configuration file as the next boot up configuration or to apply a
specific configuration to the system. This command is required when multiple configuration files
are supported.
Format
config configuration <pathname 64> [boot_up | active]
Parameters
<pathname 64> - Specifies a configuration file on the device file system.
boot_up - (Optional) Specifies it as a boot up file.
active - (Optional) Specifies to apply the configuration.
Restrictions
Only Administrators can issue this command.
Example
To configure the Switch’s configuration file as boot up: