D-Link DWS-3160-24TC - Page 212

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
208
DWS-3160-24PC:admin#config configuration config.cfg boot_up
Command: config configuration config.cfg boot_up
Success.
DWS-3160-24PC:admin#
18-3 save
Description
This command is used to save the current configuration to a file. This command is required to be
supported regardless of whether file system is supported or whether multiple configuration files are
supported. If the configuration ID or configuration file name is not specified, the next boot up
configuration is implied.
Format
save {[config <pathname 64> | log | all]}
Parameters
config – Specifies to save the configuration to a file.
<pathname 64> - (Optional) The pathname specifies the absolute pathname on the device file
system. If pathname is not specified, it refers to the boot up configuration file. This name
can be up to 64 characters long.
log – Specifies to save the log.
all – Specifies to save the configuration and the log.
Restrictions
Only Administrators and Operators can issue this command.
Example
To save the configuration:
DWS-3160-24PC:admin#save config c:/config.cfg
Command: save config c:/config.cfg
Saving all configurations to NV-RAM.......... Done.
DWS-3160-24PC:admin#
18-4 show boot_file
Description
This command is used to display the configuration file and firmware image assigned as boot up
files.