D-Link DWS-3160-24TC - Debug Stp State

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
266
Restrictions
Only Administrators can issue this command.
Example
To clear all STP counters on the Switch:
DWS-3160-24PC:admin# debug stp clear counter ports all
Command: debug stp clear counter ports all
Warning: only support local device.
Success.
DWS-3160-24PC:admin#
22-16 debug stp state
Description
This command is used to enable or disable the STP debug state.
Format
debug stp state [enable | disable]
Parameters
state - Specifies the STP debug state.
enable - Enable the STP debug state.
disable - Disable the STP debug state.
Restrictions
Only Administrators can issue this command.
Example
To configure the STP debug state to enable, and then disable the STP debug state:
DWS-3160-24PC:admin# debug stp state enable
Command: debug stp state enable
Success.
DWS-3160-24PC:admin# debug stp state disable
Command: debug stp state disable
Success.
DWS-3160-24PC:admin#