D-Link DWS-3160-24TC - Chapter 11 Auto-Configuration Command List; Enable Autoconfig; Disable Autoconfig

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
132
Chapter 11 Auto-Configuration
Command List
enable autoconfig
disable autoconfig
show autoconfig
11-1 enable autoconfig
Description
This command is used to enable the automatic configuration feature of this Switch. When
automatic configuration is enabled, during power on initialization, the Switch will get configure file
path name and TFTP server IP address from the DHCP server. Then, the Switch will download the
configuration file from the TFTP server for configuration of the system.
Format
enable autoconfig
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable autoconfig:
DWS-3160-24PC:admin# enable autoconfig
Command: enable autoconfig
Success.
DWS-3160-24PC:admin#
11-2 disable autoconfig
Description
This command is used to disable the automatic configuration feature of this Switch. When auto
configuration is disabled, the Switch will configure itself using the local configuration file