Web Operations 184
The 3G/4G Setup interface is displayed. See Figure 5-69.
After 3G/4G module is connected, the module information and wireless signal are
displayed; if not, click Search to search for wireless signal.
3G/4G setting Figure 5-69
In the 3G Network list, select the Ethernet port, and then select the Enable check box. Step 2
Configure the parameters. For details, see Table 5-27. Step 3
Table 5-27 3G/4G setting parameters description
When the Device is accessed to private network, select the NetAccess
check box, enter APN name and select authentication mode. If PAP or
CHAP is selected for authentication mode, enter user name and
password, then the Device is automatically accessed to private
network.
Displays 3G/4G network type which is used to distinguish the 3G/4G
modules among Communication Operators, such as TD-LTE.
Displays access point of Communication Operator.
If you select Customized, manually enter the APN information in the
box.
Authentication mode includes three protocols: PAP, CHAP, and
NO_AUTH. The system automatically recognizes and displays the
protocol.
Enter the dial number provided from the Communication Operator.
This parameter is available only when the authentication mode is PAP
or CHAP.
The system automatically recognizes the user name and password.
After dial-up is succeeded, all corresponding information is displayed.
Click Search to search for wireless signals.
To Next Page
Loading...
