Web Operations 189
Motion detection area setup Figure 5-75
2) Select the detection area according to the actual situation.
3) Click Save to complete the settings.
Configure the parameters. For details, see Table 5-29. Step 4
Table 5-29 Motion detect parameters description
Configure the event detection lasting time. The system records only one
event during this period.
Sensitivity for detecting alarm events.
Select the Delay Motion check box, the system detects motion events after
the delay time.
Select the Record Channel check box and select a record channel(s),
when an alarm event occurs, the corresponding channel starts recording
automatically.
The recording setting for alarm must be configured beforehand.
The motion detect recording is enabled. For details, see "5.1.8
Configuring Recording Schedule."
The auto recording is enabled. For details, see "5.1.7 Configuring
Record Settings."
Set a length of time for the Device to delay turning off alarm after it is
canceled.
Connect the alarm device such as light and siren to the alarm output port.
Select the check box of Alarm Out to enable the alarm linkage. When an
alarm event occurs, the system links the alarm device to activate alarm.
Set a length of time for the Device to delay turning off alarm after it is
canceled.
To Next Page
Loading...
