Web Operations 190
Select the Tour check box and the channels. When an alarm event occurs,
a tour of the selected channels is displayed on the Device local interface.
To use this function, make sure the tour function is enabled and the
corresponding settings are configured. For details, see "4.2.1.4.2
Configuring Tour Settings."
After tour is completed, the live view screen stays on the current image
of tour.
Select the Snapshot check box and select a snapshot channel(s). When an
alarm event occurs, the corresponding channel starts capturing
automatically.
You can also configure the frequency, size, and quality of snapshot. For
details, see "5.3.1.2.2 Configuring Snapshot Settings."
Select the Show Message check box to enable a pop-up message in your
local host PC when an alarm event occurs.
Select the Send Email check box to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled. For details,
see "5.3.2.4 Configuring Email Settings."
Select the Buzzer check box to activate a buzzer noise at the Device when
an alarm event occurs.
Select the Log check box to enable the Device to record a local alarm log
when an alarm event occurs.
Click Refresh, the system displays the latest saved configuration.
Click Save. Step 5
5.3.3.1.2 Configuring Video Loss Settings
When the video loss occurs, the system activates the alarms and links the configured actions.
Select SETUP > EVENT > DETECT > Video Loss. Step 1
The Video Loss interface is displayed, see Figure 5-76.
To Next Page
Loading...
