Enter/Exit Programming Mode Data Matrix
226
Gryphon™ I GD44XX/GBT4400/GM440X
Data Matrix Set Length 2
This feature specifies one of the bar code lengths for Data Matrix Length
Control. Length 2 is the maximum label length if in Variable Length Mode,
or the second fixed length if in Fixed Length Mode. Characters can
be set
from 0001 to 3,116 characters in increments of 0001 (pad with zeroes).
See page 283 for detailed instructions on setting this feature.
Select Data Matrix Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad
representing
your desired character(s). En
d by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
Length 2 is 3,116 Characters
To Next Page
Loading...
