Enter/Exit Programming Mode
Product Reference Guide
257
BLUETOOTH-ONLY FEATURES
The features in this section are valid only for Gryphon Bluetooth models.
Also reference the Setup section for instructions on "Linking a BT Reader to
a PC," starting on
page 26.
RF ADDRESS STAMPING
These features allow configuration of source radio data inclusion.
Source Radio Address Transmission
Enables/disables the ability of source radio address information to be
transmitted to the host and, if so, at what position with respect to the label
data. See page 302 in “References” for detailed information and examples
for setting this feature.
DEFAULT
Source Radio Address Transmission = Do Not Include
Source Radio Address Transmission = Prefix
When included as a prefix, the source-radio ID is displayed after all
label formatting has been applied. The 6 byte hex address is sent as
12 ascii characters, i.e., an address of 00 06 66 00 1A ED will be sent as
(shown in hex): 30 30 30 36 36 36 30 30 31 41 45 44
To Next Page
Loading...
Need help?
General
