Datalogic Gryphon I GD44XX User Manual

Enter/Exit Programming Mode
88 Gryphon™ I GD44XX/GBT4400/GM440X
Global Prefix/Suffix
This option sets up to 20 characters each from the set of ASCII characters or
any hex value from 00 to FF. The characters may be added as a prefix (in a
position before the bar code data, also called a header) and/or as a suffix (in
a position following the bar code data, also called a footer). See page 285
for more detailed instructions on setting this feature.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar
c
ode above to place the unit in Programming Mode, then the “Set Global
Prefix” or “Set Global Suffix,” bar code followed by the digits (in hex) from
the Alphanumeric characters in Appendix D Keypad representing your
desired character(s). If less than the e
xpected string of 20 characters are
selected, scan the ENTER/EXIT bar code to terminate the string. Exit pro-
gramming mode by scanning the ENT
ER/EXIT bar code again.
$CLFPR
Set Global Prefix
$CLFSU
Set Global Suffix
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
No Global Prefix
Global Suffix = 0x0D (CR)

Datalogic Gryphon I GD44XX Specifications

General

Brand	Datalogic
Model	Gryphon I GD44XX
Category	Barcode Reader
Language	English