Setup
34
Gryphon™ I GD44XX/GBT4400/GM440X
Customizing Configuration Settings
Configure Interface Settings
If after scanning the interface bar code from the previous table, your instal-
lation requires you to select options to further customize your reader, turn
to
the appropriate section for your interface type in "Configuration Parame-
ters" starting
on page 39.
• "RS-232 Interface" on page 43
• "RS-232/USB-Com Interfaces" on page 48
• "Keyboard Settings" on page 67
• "RS-232/USB-Com Interfaces" on page 48
• "IBM 46XX Interface" on page 79
• "Wand Emulation Interface" on page 83
Global Interface Features
See "Global Interface Features" on page 41 for settings configurable by all
interface types.
Configuring Other Features
If your installation requires different programming than the standard factory
default settings, the following sections of this manual allow configuration of
non-interface-specific settings you might require:
Reading Parameters
:
Reading Parameters include programming for scanning,
beeper and LED indicators and other universal settings.
1D Symbologies
:
Includes options concerning the bar code label types (sym-
bologies). These settings allow you to enable/disable symbologies, set label
len
gths, require check digit, etc.
WIRELESS FEATURES
:
Contains programming options for RF, STAR and Blue-
tooth models only.
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and
Keyboard interfaces by scanning the following label.
Transmit Software Version
RevA
To Next Page
Loading...
Need help?
General
