Datalogic Gryphon I GD44XX User Manual

Enter/Exit Programming Mode Micro QR Code
240 Gryphon™ I GD44XX/GBT4400/GM440X
Micro QR Code Set Length 1
Specifies one of the bar code lengths for Micro QR Code Length Control.
Length 1 is the minimum label length if in Variable Length Mode, or the first
fixed length if in Fixed Length Mode. Ch
aracters can be set from 0001 to
0035 characters in increments of 0001 (pad with zeroes).
See page 283 for detailed instructions on setting this feature.
$CMQL1
Select Micro QR Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing
your desired character(s). En
d by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
0001 = Length 1 is 1 Character

Datalogic Gryphon I GD44XX Specifications

General

Brand	Datalogic
Model	Gryphon I GD44XX
Category	Barcode Reader
Language	English