Setup
36
Gryphon™ I GD44XX/GBT4400/GM440X
Replacing the Battery
Before replacing the Battery, read
"Battery Safety"
starting on page 6. Datalogic rec-
ommends annual replacement of rechargeabl
e battery packs to ensure maximum per-
formance.
To change the battery of your reader, complete the following instructions.
1. With a screwdriver, unscrew the battery cover screw.
2. Unscrew and remove the three screws securing the battery holder, and
unplug the white connector.
3. Carefully lift out the gold contacts circuit, and remove the battery
holder while letting the white connector pass through the hole in the
battery holder (as shown in the picture below).
4. Remove the old battery from its place (if present), and insert the new
battery in the same position.
Pass-through
hole
Gold
contacts
circuit
To Next Page
Loading...
