Micro QR Code Enter/Exit Programming Mode
Product Reference Guide
241
Micro QR Code
Set Length 2
This feature specifies one of the bar code lengths for Micro QR Code Length
Control. Length 2 is the maximum label length if in Variable Length Mode,
or the second fixed length if in Fixed Length Mode. Characters can be set
from 0001 to 0035 characters in increments of 0001 (pad with zeroes).
See page 283 for detailed instructions on setting this feature.
Select QR Code Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad
representing
your desired character(s). End by scanning the
ENTE
R/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code t
o abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
Length 2 is 0035 Characters
To Next Page
Loading...
