Datalogic Gryphon I GD44XX User Manual

Enter/Exit Programming Mode Maxicode
228 Gryphon™ I GD44XX/GBT4400/GM440X
Maxicode Length Control
This feature specifies either variable length decoding or fixed length decod-
ing for this symbology.
Variable Length: For variable length decoding, a minimum and maximum
length may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
DEFAULT
$CMXLC00(CR)
Maxicode Length Control = Variable Length
$CMXLC01(CR)
Maxicode Length Control = Fixed Length
Maxicode Set Length 1
Specifies one of the bar code lengths for Maxicode Length Control. Length 1
is the minimum label length if in Variable Length Mode, or the first fixed
length if in Fixed L
ength Mode. Characters can be set from 0001 to 0145
characters in increments of 0001 (pad with zeroes).
See page 283 for detailed instructions on setting this feature.
$CMXL1
Select Maxicode Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing
your desired character(s). En
d by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
0001 = Length 1 is 1 Character

Datalogic Gryphon I GD44XX Specifications

General

Brand	Datalogic
Model	Gryphon I GD44XX
Category	Barcode Reader
Language	English