Datalogic Gryphon I GD44XX User Manual

Enter/Exit Programming Mode
72 Gryphon™ I GD44XX/GBT4400/GM440X
Wedge Quiet Interval
Specifies amount of time to look for keyboard activity before scanner breaks
keyboard connection in order to transmit data to host. The selectable range
for this setting is 00 to 990 milliseconds (00-0x63 by 01) in increments of
ten milliseconds.
See page 280 in “References” for detailed information and
examples for setting this feature.
$CKBQI
Set Wedge Quiet Interval
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the
bar code at left followed by the digits from the
Alphanumeric characters in
Appendix D, Key-
pad representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abor
t and not save the entry string. You can then
start again at the beginning.
~
CANCEL
DEFAULT
0A = Quiet Interval is
100 milliseconds
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface.
The selectable range for this feature is from 0 to 99 seconds.
See page 282 in “References” for detailed information and examples for set-
ting this feature.
$CKBID
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the
bar code at left followed by the digits from the
Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abor
t and not save the entry string. You can then
start again at the beginning.
~
CANCEL
DEFAULT
00 = No Wedge Intercode Delay

Datalogic Gryphon I GD44XX Specifications

General

Brand	Datalogic
Model	Gryphon I GD44XX
Category	Barcode Reader
Language	English