Datalogic Gryphon I GD44XX User Manual

Message Formatting
308 Gryphon™ I GD44XX/GBT4400/GM440X
when the code is received from the cradle. (See "Wireless Beeper Fea-
tures" on page 248).
The message field can store plain text a
nd escape sequences.
• Escape sequences are interpreted as commands.
LED and Beeper Control
ESC [ 0 q Emit short High tone + short delay
ESC [ 1 q Emit short Low tone + short delay
ESC [ 2 q Emit long Low tone + short delay
ESC [ 3 q Emit good read tone
ESC [ 4 q Emit bad tx tone
ESC [ 5 q Wait 100 ms
ESC [ 6 q Turn on the green LED
ESC [ 7 q Turn off the green LED
ESC [ 8 q Turn on the green spot
ESC [ 9 q Turn off the green spot
ESC [ 0 r Beep for Find me function (new)
ESC [ 1 r Power-off (new)
The LED control escape sequences are intended to activate the LEDs for
short periods of time and can be used in combination with the Beeper. The
LED and Beeper will be controlled by the system after the entire command
sequence is interpreted.
Example:
ESC [ 6 q ESC [ 3 q ESC [ 7 q
Turns on the green LED, emits a good read tone, and turns off the green
LED.
ESC [ 6 q ESC [ 5 q ESC [ 7 q Turns on the green LED for 100 ms and then turns off the green LED.
Escape sequences different from those listed will be ignored.

Datalogic Gryphon I GD44XX Specifications

General

Brand	Datalogic
Model	Gryphon I GD44XX
Category	Barcode Reader
Language	English