Datamax E-Class Mark II Programmer's Manual

Extended System-Level Command Functions
82 Class Series 2 Programmer’s Manual
(NT) Network Setup – (for firmware version 13.99 and earlier) This command
configures the printer for an Ethernet connection.
Value Parameter Interpretation Default Value
*
A x
Is the transmission interval for
Gratuitous ARP, where:
x = The interval, 0 – 2048, in minutes
0
B y
Is Network Bios Name, where:
y = Up to 16 alphanumeric characters,
no spaces
DMX_[and the last
3 octets (in
hexadecimal) of
the MACM (or
MACO) Address]
C x
Transmits the printer’s Wired network
communication capability, where x:
0 = Advertises the DUPLEX CAPABILITY
set value.
1 = Advertises all possibilities for
DUPLEX CAPABILITY.
0
D a
Is Discovery (DHCP or Bootp), where a:
Y = Enable
N = Disable
Y
E x
Is the communication capability for the
Wired network, where x:
0 = Auto-Negotiate
1 = 10Base-T, Half Duplex
2 = 10Base-T, Full Duplex
3 = 100Base-T, Half Duplex
4 = 100Base-T, Full Duplex
0
F a
Is FTP enable, where a:
Y = Enable
N = Disable
N
G xxx.xxx.xxx.xxx
Is the Gateway Address, where:
x = 0 to 9
000.000.000.000
(continued)

Datamax E-Class Mark II Specifications

General

Resolution	203 dpi (8 dots/mm) or 300 dpi (12 dots/mm)
Operating Temperature	40°F to 95°F (4°C to 35°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Print Method	Direct Thermal / Thermal Transfer
Max Print Speed	6 inches per second (ips)
Memory	8 MB DRAM
Interface	Serial, Parallel, USB
Media Type	Labels, Tags, Receipts
Media Width	0.75" (19 mm) to 4.65" (118 mm)
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Power Requirements	100-240 VAC, 50-60 Hz