Datamax E-Class Mark II Programmer's Manual

Extended System-Level Command Functions
122 Class Series 2 Programmer’s Manual
STX KuW Write Data to RFID Tag
(Direct Mode – UHF Interface – Hexadecimal Data Only)
This command instructs the RFID device to write data to the tag. It is expected that the
tag transponder will be within the read / write distance of the RFID programming device;
otherwise, a warning will occur and a warning message (Read / Write Fail) will be
displayed.
Syntax:
<STX>KuWabcc…c<CR>
a
-
The number of attempts to locate, erase and program
the tag (1 – 9).
b
-
Reserved. Should be 0.
Where:
cc…c
-
Data to be encoded in the ASCII format. Must be
sixteen characters in length. The valid characters are
0-9, A-F.

Must be 16 or 24 characters long.
Sample:
<STX>KuW10ABCDEF0102030405[CR]
The sample above programs the data
<0xAB><0xCD><0xEF><0x01><0x02><0x03><0x04><0x05> to the
tag, attempting to write one additional time if necessary.
STX KV Verifier Enable/Disable
This command allows a verifier to be enabled and disabled.
Syntax:
<STX>KVa<CR>
Where:
a
- Y = verifier enable
N = verifier disable
STX KW Memory Configuration, Printable Label Width
See the <STX>K command for details.

This command will result in a system reset for the EX2.

Datamax E-Class Mark II Specifications

General

Resolution	203 dpi (8 dots/mm) or 300 dpi (12 dots/mm)
Operating Temperature	40°F to 95°F (4°C to 35°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Print Method	Direct Thermal / Thermal Transfer
Max Print Speed	6 inches per second (ips)
Memory	8 MB DRAM
Interface	Serial, Parallel, USB
Media Type	Labels, Tags, Receipts
Media Width	0.75" (19 mm) to 4.65" (118 mm)
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Power Requirements	100-240 VAC, 50-60 Hz