Datamax E-Class Mark II Programmer's Manual

System-Level Command Functions
26 Class Series 2 Programmer’s Manual
STX o Cycle Cutter
This command will cause the optional cutter mechanism to immediately perform a cut
after all previously received commands are executed. The cutter must be installed,
enabled and the interlock(s) closed for operation.
Syntax:
<STX>o
STX P Set Hex Dump Mode
This command instructs the printer to assume Hex Dump Mode. Instead of a formatted
product, data sent following this command will be printed in its raw ASCII format. To
capture all data, labels should be at least four inches (102 mm) long and as wide as the
maximum print width. This command has the same effect as turning “On” the printer
while depressing the FEED Key (return normal operation by manual reset).
Syntax:
<STX>P
Printer response is
data dependent
(layout may vary):
STX p Controlled Pause
This command will cause the printer to pause only after all previously received
commands are executed, often useful between label batches. (This command will not
clear the pause condition; see <SOH>B).
Syntax:
<STX>p

Datamax E-Class Mark II Specifications

General

Resolution	203 dpi (8 dots/mm) or 300 dpi (12 dots/mm)
Operating Temperature	40°F to 95°F (4°C to 35°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Print Method	Direct Thermal / Thermal Transfer
Max Print Speed	6 inches per second (ips)
Memory	8 MB DRAM
Interface	Serial, Parallel, USB
Media Type	Labels, Tags, Receipts
Media Width	0.75" (19 mm) to 4.65" (118 mm)
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Power Requirements	100-240 VAC, 50-60 Hz