Datamax E-Class Mark II Programmer's Manual

Extended System-Level Command Functions
Class Series 2 Programmer’s Manual 105
STX KF Select Factory Defaults
This command restores the configuration of the printer to the factory default settings.
These settings may be default values or the values previously specified by a
configuration file (see <STX>Kd).
Syntax:
<STX>KFn<CR>
n
- 2 = Returns the factory default settings (and, if saved,
restoring the Factory Setting File).
Where:
-
3 = Returns the factory default settings, and clears
Calibration and Custom Adjustments.

Calibration will be required.
STX Kf Set Present Distance
This command specifies an additional amount to advance the label after printing. This
command has the same effect as the <STX>f command, but specifies a distance to
advance relative to the start of print (<STX>O command) of the next label.
Non-Display Models: The printer Option Control must be set (via the menu) to HOST for
this command to have effect.
Display-Equipped Models: SOP Emulation selection has no effect on this command.
Syntax:
<STX>Kfnnnn<CR>
Where:
nnnn
- A four-digit present distance in inches/100 or mm/10.
Sample:
<STX>Kf0100
The sample above represents a one-inch label advance unless in
metric mode (see <STX>m).

Datamax E-Class Mark II Specifications

General

Resolution	203 dpi (8 dots/mm) or 300 dpi (12 dots/mm)
Operating Temperature	40°F to 95°F (4°C to 35°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Print Method	Direct Thermal / Thermal Transfer
Max Print Speed	6 inches per second (ips)
Memory	8 MB DRAM
Interface	Serial, Parallel, USB
Media Type	Labels, Tags, Receipts
Media Width	0.75" (19 mm) to 4.65" (118 mm)
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Power Requirements	100-240 VAC, 50-60 Hz