Label Formatting Command Functions
Class Series 2 Programmer’s Manual 129
E Terminate Label Formatting Mode and Print Label
This command causes the printer, when the processing Label Formatting commands, to
terminate the Label Formatting Mode then generate, print, and feed a label. The label
generated will be based on whatever data has been received to that point, even if no
printable data has been received. (Other termination commands are “X” and “s”.)
Commands sent to the printer after the Terminate Label command must be of the
Immediate, System-Level, or Font Download type.
Syntax:
E
Sample:
<STX>L<CR>
121100000000000Testing<CR>
E<CR>
The sample above will print one label.
e Recall Printer Configuration
This command recalls a previously stored printer configuration. It is highly
recommended that only one Recall Printer Configuration command be used per label,
and that it be used at the beginning of the label; otherwise, unpredictable results will
occur. (Printer configurations may be stored using the Extended System-Level
Commands or via the printer’s menu system.)
Syntax:
eName<CR>
Name
-
The name, up to 16 characters, of the configuration
file.
Where:
<CR>
-
0x0d terminates the name.
Sample:
<STX>L<CR>
ePlant1<CR>
1A2210001000000Testing<CR>
E<CR>
The sample above recalls the stored printer configuration, Plant1.
F Advanced Format Attributes
These commends extend the text presentation capabilities for Scalable Fonts. The
format attribute allows a set of label format records to select Bolding, Italicizing and
Underlining. Additional commands allow the specification of line rotation and font
changes within a label field. See “Advanced Format Attributes” (Section 8) for details.
To Next Page
Loading...
Need help?
General
