Datamax E-Class Mark II Programmer's Manual

System-Level Command Functions
Class Series 2 Programmer’s Manual 33
STX w Test Flash Memory Module
This command tests the Flash module. The time for each test will vary from 20 to 120
seconds, depending upon the size of the module. All stored data will be destroyed. If
no module is present, there will be no printer response.
Syntax:
<STX>wa
Where:
a
-
Module designator; see Appendix K.
Response format:
Module A: xxxxK results
Where:
A
-
Module tested.
xxxx
-
Module size in Kbytes.
results - Test results given as “Good” or “Bad”.
STX X Set Default Module
This command, typically used prior to the loading of PCL-4 bitmapped fonts (see Font
Loading Commands), is designed to allow the user to select between modules when
downloading information. The default module is one of the following:
1. The first alpha designator of the existing modules if item 2 has not occurred.
2. The module selected by this command.
Syntax:
<STX>Xa
Where:
a
- Module designator; See Appendix K.
Sample:
<STX>XB
The sample above sets “B” as the default module.

Datamax E-Class Mark II Specifications

General

Resolution	203 dpi (8 dots/mm) or 300 dpi (12 dots/mm)
Operating Temperature	40°F to 95°F (4°C to 35°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Print Method	Direct Thermal / Thermal Transfer
Max Print Speed	6 inches per second (ips)
Memory	8 MB DRAM
Interface	Serial, Parallel, USB
Media Type	Labels, Tags, Receipts
Media Width	0.75" (19 mm) to 4.65" (118 mm)
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Power Requirements	100-240 VAC, 50-60 Hz