Datamax E-Class Mark II Programmer's Manual

Extended System-Level Command Functions
Class Series 2 Programmer’s Manual 115
STX KtA Write Application Family Identifier (AFI) to Tag
(Direct Mode – HF [13.56 MHz] ISO15693 Tag Interface)
This command writes the AFI data to the tag.
Syntax:
<STX>KtAabcc
a
- The number of retry attempts, 0-9.
b
- Lock the Application Family Identifier (AFI) after writing:
0 = No Protection
1 = Write Protect
Where:
cc
- Two character AFI value representing one byte.
Sample:
<STX>KtA91C3[CR]
The sample above writes 0xC3 AFI byte, locking value, retrying
nine times if necessary.
STX KtD Write Data Storage Format Identifier (DSFID) to Tag
(Direct Mode – HF [13.56 MHz] ISO15693 Tag Interface)
This command writes the DSFID data to the tag.
Syntax:
<STX>KtDabcc
a
- The number of retry attempts, 0-9.
b
- Lock the Data Storage Format Identifier (DSFID) after
writing:
0 = No Protection
1 = Write Protect
Where:
cc
- Two character DFSID value representing one byte.
Sample:
<STX>KtD91C3[CR]
The sample above writes 0xC3 DSFID byte, locking value, retrying
nine times if necessary.

Datamax E-Class Mark II Specifications

General

Resolution	203 dpi (8 dots/mm) or 300 dpi (12 dots/mm)
Operating Temperature	40°F to 95°F (4°C to 35°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Print Method	Direct Thermal / Thermal Transfer
Max Print Speed	6 inches per second (ips)
Memory	8 MB DRAM
Interface	Serial, Parallel, USB
Media Type	Labels, Tags, Receipts
Media Width	0.75" (19 mm) to 4.65" (118 mm)
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Power Requirements	100-240 VAC, 50-60 Hz